0:00
My fun new gadget came
0:05
It's very, very simple. My first step was to line up this part here right down the middle here
0:13
I wanted it just in the middle of the wand in the wand here
0:19
Very simple to do that. You just unscrew these, tighten it up, and line it up
0:25
Next step was to line up my holes for my handle with these holes here
0:32
I lined that up and tightened. We're ready to use it on our actual cabinet drawer
0:41
What I did was I found my center. I made some pretty big lines on here
0:45
I don't know if you can see that. I don't need to make that deep of lines, but I did use a pencil so I can erase them
0:53
I'm going to line up my ruler up here. It goes up there so that it has a nice place to sit
1:01
I'm going to make sure that my line here, this little, there's a little arrow here
1:08
and it's going to line up with my center. Then I can tighten this part over here just to make sure that that's not going to move
1:19
It's nice and sturdy. I'm good to go. Then I'm going to just drill my holes here and here, and it'll be all lined up exactly
1:28
how we need it. All right, so now I have my two holes drilled here, center with where they need to be
1:37
Now I'm going to take my handle, put it on there, and make sure that we're all good
1:51
It's that simple. They're lined up, and it's in the center. I'll get rid of my lines, my pencil lines, and it's good to go
2:20
The hardware is completely finished. Yes, I am so happy for that
2:26
Even up there, it is all done